Team Camaro Tech banner

inner wheel well

800 views 2 replies 2 participants last post by  DT 
#1 ·
I need a couple of repair patches on my inner wheel wells. This is for a vert. Think I should just replace the inner ??? Not sure I could get to all the spot welds for the trunk support and convertible top support. The 1/4's are on the car. Any thoughts, doubts, recommendations ?? Thx
 
#3 ·
I just received the USA made inners. They look pretty good. Initially I was going to butt weld the piece in (pretty much lower 2 inches of inner) but now I'm thinking just lap joint the new repair piece. Save a lot of time and I don't have to be 100% balls on with my cut.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top