- Re-chroming a bumper..
- Firewall Color??
- Pressure Setting for Ox-Acetelene
- 69 camaro need partial patch panel
- Whew
- Another Quarter Question
- Outside door handles
- New dynacorn doors/trunk lid?
- Quarter Panel difficulty (compared to cowl)
- Pulling my hair out, help
- Butt weld a fender patch?
- front clip
- rocker panels
- epoxy primer
- Paint over Primer w/o sealer
- MiniTub after Paint.
- Almost finished
- lower body trim
- Fender Emblem needed
- Sheet metal warpage prevention
- Floor Pan Support for Coupe?
- Best way to remove glass ??
- Tools for the Pro (or serious hobbiest).
- Cleaning fender bolts.
- wiper assembly finishes
- hood latch spring
- Where do I get rear inner fender wells for '68 Camaro?
- Rear Quarter Work
- electroplated
- Riveting Header to grille?
- Another one almost done......
- Where to find: channel area around rear windshield without replacement quarters
- Mig or flux
- Car Bra for First camaro
- Media Blaster on Long Island
- Rear Frame Rail Repair
- ATF and Clearcoat
- Air Compressor Line
- High Temp Door Sag
- Trunk Lid Questions
- mig welder options
- RS conversion
- Ratty Bumper Refurb Ideas?
- standard gs caps for a 68'
- Daytona Welders?
- fenders for a 69
- quarter panel pics
- Paint Removal and Priming
- exterior body trim
- Paint body before...
- Functional Rear Quarter Air Intake?
- Rebuilding a burnt car
- So confused Classic Ind v Ricks v Dynacorn
- Seam Selaer On Wheel Wells?
- repro drip rails
- Detroit speed deep tubs
- Paint or undercoating on bottom of body?
- Hockey Stripe on Non SS Car ???
- Rear Wheel wells
- Quality of 69 coupe rocker panels?
- Front Grill Removal on 68
- I'll Need Fenders Too
- 69 Gas Tank.
- Floor Pan Fit Problems
- RS Fender adapters
- Sequoia Green
- Mig Wire Size?
- Whats the difference???
- Got the car back from blasting......
- rust converter
- Floor pan problem
- How do I replace the filler panel rain gutter?
- vinyl top camaros
- Replacing drip rails without removing roof skin?
- Standard grille kits
- wiper arm
- Convertible quarters
- sikkens paint colors
- trunk measurement needed
- Window Trim Removal
- 69 SS rocker black
- finished painting the 1922 Hispano-Suiza
- weatherstripping kit
- Door Alignment
- shock tower panels
- Dash Replacement Need Measurements
- Need 69 Coupe Uni-Body Floor Specs.
- Rear window: metal studs for the window clips necessary?
- Another frame rail question
- Rear Quarter Panel Braces
- removing undercoating
- Are 67 camaro inner fender same as F-Bird?
- Quarter Rear Window Opening Braces
- DeVilbiss Compressors?
- 69 Camaro Rear Spoiler
- removing full quarters
- trunk floor?
- Full trunk floor pan question.
- Very productive day!
- Removing Clear Coat Scratches On Black Car
- Door and trunk gaps
- Art Morrison Frame and Suspension
- 67 Door glass???????????
- Rear Quarter Patch Panel Installation
- Clear Coating A 10yr Old Enamel Paint Job?
- 70's style bullet mirror install question
- 87 body kit
- Storing Hood
- how do I align new gas tank
- Painting rust with POR15
- Pulling front clip this weekend. Anything else...
- Body Panel question
- 81 z quarters
- victory red on a 67 rs
- Is there a smart choice here.
- scotch brite pads?
- What size sockets needed to dissasemble front end sheetmetal
- 2k AEROSOL epoxy primer, filler primer AND clear!
- Clausen ALL-U-NEED Primer
- A couple of stripe and rocker paint questions.
- firewall paint
- Homemade 69 ?
- 69 RS fender emblem help needed
- Vent Window Frame
- spot welds on quarter
- Pull subframe w/ engine and tranny in?
- bucket seat paint color
- What Color?
- Full trunk floor replacement - 68 camaro
- Tenacious paint?
- core support bushings install
- Spoiler Question
- Finally found someone to take care of the body in my 68
- 1969 Camaro Trunk Springs
- metal finishing pictures-no bondo repair
- Paint it Black?
- Advice on 75/25?
- Need 68 vinyl top stud locations
- Ready for paint
- '68 rear spoiler GM or repro?
- 89 camaro floor/trunk pan replacement
- what type of pipe should i make my air lines out of?
- Chrome Tinting
- Body filler question
- do they make a patch panel for this yet
- One quick question: Epoxy prime new coated panels?
- Powder coating brake parts? QUICK!
- Install Front Bumperetts on 69
- Install Front Bumperetts on 69
- frame question
- What goes where on core support
- guidecoat
- Fuel line / brake line color?
- spoiler install
- Old Lacquer Paint
- Anyone Using A 3m Gvp Psk System?
- Pulled front clip today!
- paint car with the frame on?
- trunk lid adjustments
- anybody try bonding your body panels on?
- Placement of Front Fender Emblems on 1968 Z/28 Camaro
- Another windshield moulding question...sorry
- Loose hood hinges
- Daytona Yellow Color Mix
- painting jambs and hinges
- Anyone Replaced Windows In A 1st Gen???
- Anybody convert RS fenders to standard?
- Cowl Plenum Firewall Hole
- etch primer/ sealer primer question
- front bumper
- Remove tunnel or not
- ordering fenders and hoods online??
- New Quarter Fitment Issue
- Clearcoat went wrong started cracking
- best type of welder to use
- Which epoxy primer is best?
- Help with paint nozzle size 1.4
- Undercoat Removal
- Underhood Undercoat Removal
- RS Gas Cap
- Some progress!
- Best Fix ideas?
- Can I buy just front roof support?
- Paint formula?
- Inspiration Moment
- sanding por-15 ???
- Bondo repair shows through
- sheet metal work
- camaro bodies 101
- Im back ;)
- epoxy primer over body putty
- Rear Window To Trunk Piece
- Removing old rocker panels
- Got my car back today...
- painter for hire?
- ZL1 fender emblems
- Temporary Paint Booth Ideas
- Oh God I"m In Trouble
- POR-15 products
- Bodywork On Rear Spoiler
- Have a question about, and need pics of blacked out rockers on a 69.
- Why is BC/CC more forgiving than Single Stage?
- Removing quarter panel louvers
- Need Stiffener
- 67 SS/RS Emblem Location
- Painting Balancer
- More Updates. Pics....
- Need a little help!
- windshield markings
- First Pics of the '69's Rear
- Painting chrome
- Antenna Mount Problems
- Mig Problems
- convertible bending problems
- Cutting sheet metal for center dash panel cover
- Pro-Touring '69 Firebird Build
- reproduction glass
- Fender Date Codes
- My frame rail, what is this?
- Powdercoating!
- *pics* my new lower quarter skin welded in
- test fitted the grill... the fit is horrible!
- Hugger Orange question...
- Can anything else be shot.
- trying to prime
- front bumper delete
- Cocktail shaker missing.
- Almost finished finally
- Structural adhesives
- Removing Overspray... How To...
- 69 Quarter Gills
- crash manuals/measurements
- MIG welder gas pressure
- Welding in a Trunk Pan?
- powder coating
- What could I do with my Antenna hole?
- help me adjust doors
- RS option
- "Basics of Basics" Floor welding tip.
- 1969 door to quarter gap
- 1969 deck lid to quarter gap
- 67 Vent window availability ?
- The quarter question
- Advice on wire(JW Harris)
- broken bolts in rear shock mounts
- Trim Questions
- New quarters
- Squeegeeing out primer? Maybe
- Window Hedache
- Rick's First Gen USA made parts