- Anybody know alot about rearends?
- 69 4speed shifter questions
- muncie hanging up
- Transmission question
- Bad Vibrations
- 12 bolt axle id help
- 11" Clutch
- how to install muncie 4 speed or th700r4 from th350 setup?
- Hyraulic clutch questions
- wrong clutch pedal..?
- Turbo 400 driveshaft swap
- Numbers decoding positraction 79 Camaro
- 4 speed Muncie Shifter Handle
- Leaky Pinion
- Pulling 4 saginaw
- 67' Clutch Linkage HELP!!
- Transmission swap parts
- Dana 60 gear install
- Clutch Size And Type
- turbo 350 transmission won't shift out of 1st gear
- Question about Hurst linkage?
- Tranny Housing
- Clutch help
- Final gear swap suggestions.
- Stock Shifter
- Tranny Swap
- Kick down cable
- TH400 rebuild questions
- Centerforce DF question
- Too much HP dont want to twist anything!
- Dana 60 c-clip eliminator attn :Big Gear Head
- M-20 yoke spline engagement
- Torq converter lock up?
- Rear Axle decode
- Poly trans mount questions????
- Borg warner ST10?
- Need pics of Hurst Comp Plus linkage
- can you launch in 2nd- with 700R4 manual valve body???
- Bent finger on pressure plate?
- knocking noise
- 700r4 question.
- Pressure Plate Bolt Hole Stripped
- 700r4 with Column shift
- finally figured out where the problem is.
- Shifter problem on TH 350?
- lockright trouble
- 8.5 10 bolt rear end
- 700R4 conversion help
- TH350 Problems
- tranny mounts
- Muncie 4 speed ID Please
- How to adjust TH350 Kickdown Cable?
- 1992 Z-28 and 1992 RS differential
- Stupid ? about a flywheel?
- TH350 Shift Select Lever for 68 Camaro
- TH350 crossmember
- Quick Question
- Help what gears do i have
- Which flywheel? 327 to 383
- overdrive problem
- 69 Driveshaft Specs for Diff Transmissions ???
- 6 to v8
- Clutch Fork Length -Problem?
- 2 Speed Powerglide
- Tremec advise
- What have I done WRONG????
- I broke the dentent cable plastic, now what?
- Help ID shifter on ebay
- Transmission swap
- TH350 shifter adjustment
- Transmission lines clip on engine oil pan?
- Whats the biggest driveshaft you are running?
- Engine kickdown bracket TH350
- 8.2 or 8.5?
- Clutch Pedal adjustment
- Installing a 200R4
- Installing a 700R4
- Th350c
- Torque Specs.
- T350 rear mount bolts
- Starter won't fit
- muncie m20 july 68
- Drive Gear
- TKO 600/408sbc/3.55's good match?
- speedo cable
- Advice on installing new gears
- 67-69 4spd Driveshaft NEEDED
- Mobile 1 Synth Gear Lube in M22
- Flywheel # 366861n gbody to a 67 camaro 327...org part # 3791021
- HELP!!! Flywheel # 366861n gbody to a 67 camaro 327...org part # 3791021
- TH350 problems
- Which rear end gear?
- t-56 install
- differential numbers
- Th-350 Transbrake
- New axle bearings and seals
- TKO-600 install questions
- Torque converters
- M-20 fluid type
- Need some help on a found rear.
- rearend advice
- Repro Z bars US made vs. Import
- Adjusting kickdown
- Stripped hole on Muncie casing
- TH400 Shift Selector Shaft Seal
- Muncie Input shaft-bolt locks
- Transmission Color
- Brake Proportioning Valve Color
- What lube for Eaton posi?
- Loud Clunk Help...
- Another rear end numbers post
- Scatter Shield Alignment ??
- Changing 12 bolt housing seal
- TH-350 Speedometer leak?
- 12 Bolt Question
- Backdrive picture
- 67 camaro bench seat 4 speed shifter
- Wifes Ford Please Help
- Pypes 2.5" Exhaust Kit SGF08--Stranded...
- Muncie wont go into gear?
- bellcrank question
- What muncie do I need??
- Advice please re: 12 bolt & leaky tranny
- Clutch pedals
- Leaky Powerglide
- new 200 page gm 2004r transmission technical manual
- Strange engineering
- Why order a 2:73 POSI back in 67,68,69??
- Transmission/torque converter problem
- Upgrade to 30 spline?
- 700r4 who has done it?
- Rebuilding entire rear of car
- How to stop detent cable leak?
- Speedo Adapter question
- 250 6 Cyl / 4 speed
- Rear end gearing for BBC & Tremec
- calling brichead
- Column Shifter Linkage - Powerglide to Turboglide Swap
- Classic Chevy 5-Speed & GM Jim team up!
- Muncie M20
- Can anyone give me an idea of my gear ratio
- big block transmission/shifter question
- Richmond 5 speed trans mount Linkage hole
- Problem with Transmission
- Trsnsmission mout
- tranny knocking in 1,2 and 3rd gear
- On a rear drum brake 68 is it normal for the wheel to move in and out a little
- Hello everyone!...I have a cable question.
- 67 muncie Driveshaft Continued....
- M21 jumping out of 3rd gear
- posi troubles
- 2 or 3 Series Carrier??
- kickdown adjustment problem th350
- Rear axle noise
- Rear Axle noise help
- InputPinion or Differential
- '00 Chevy Camaro Rear Diff Problems-Help!
- gear
- new diff. cover gasket, sealer or not?
- Harmonic vibration at 4400 RPMS
- 12bolt or 10 bolt?
- Won't shift into second (M21) and clutch question
- long Throwout bearing
- M21 and 3:08 gears
- McLeod scattershield part number ??
- Bell Housing Blues
- Saginaw Shifter
- 12 bolt in 67 RS?
- Gear ratio questions
- Eaton Posi Package on ebay
- SEMA show in November
- HELP! Clutch Linkage Again! HELP!
- Use reg oil or Amsoil 2000 to break in rearend
- Manual valve body for street? conversion?
- Alum Carrier for 9" by Strange
- tko600 with ls1
- Open end vs. Posi
- Rear axle seal keeps leaking
- Axle problem
- How much runnout should a drive shaft have?
- Where can I find a picture of the 10 bolt
- Ring gear bolts missing
- leak in TH350 coming from kick down, how to fix?
- clutch recommendation for Saginaw 4spd..
- vibration under heavy acceleration
- Rear pinion seal is leaking
- Speedometer Gear
- 4 speed swap
- Powerglide Behavior?
- floor shift 3 spd
- Ring Gear numbers
- Best 5 Speed
- rear diff swap
- TKO overdrive w/ 2.73:1
- Super T-10 w/ 3.42 first
- Bellhousing I.D...?
- removal of pinion nut
- Super T-10 ID
- Lakewood bellhousing
- Pinion seal cover
- th350 won't downshift to 1st
- 69 Camaro lock out linkage
- Looks like I got a truck bellhousing
- Tag on 4 spd transmission
- 67 differential
- 67 differential
- no manual downshift in th350
- loud noise coming from trans..help
- Offset Yolks
- T-56 Hyd clutch bracket (67-69)
- Clutch adjustment trouble
- Turbo 400 RPM drop
- powerglide
- Torque spec for a cannister style oil filter?
- th400 speedo gear
- torque converter bad?
- Budget rear disk with a 9"...?
- flywheel
- Balancing Question
- Lakewood bellhousing with TKO
- LS1 and a 700R4?
- Hard Shifting 4L60E
- Very noisy strange sounding Muncie
- Pic of 69 Hurst Shifter bracket
- Tremec TKO problems
- 99 camaro Tranny Slips
- 68/69 console upper boot w/ TKO 600
- centerforce clutch.
- Turbo 350 puking fluid out dipstick
- Automatic Trans for 72 Z-28
- Speedo gear on the drivers side of muncie??
- Will this posi unit work?
- best tranny for a 502
- unidentifed trans
- Mixing & matching a posi 8.2
- hydraulic clutch
- 700R4 dip stick
- Trans Wires
- Trans Wires
- Clutch/flywheel mismatch?
- 700R4 Install cost?
- 67 camaro rear end info
- 700R4, Converter and rear gear question?
- I miss my car
- Tapered 12 bolt
- Turbo 350 trans filter removed please look
- When car is in drive, it looses power
- gear ratio identification
- Tremec Vs Richmond five speed
- Going to a 9" but what gear ratio & carrier?