- what do u guys think about this?
- Poly Transmount question
- Shifter Lube?
- Lock-up vs. non-lock-up
- Posi or not?
- TKO 600 shifter question
- Tranny problems?
- tranny dbolt torque specs
- Rear end code location.
- Hurst Reproduction shifter
- Richmond 5 speed Doug Nash
- Gasket or RTV on rear cover??
- Jerky acceleration, Tranny slipping?
- Lockup or not?
- Leaking Rear Axle Seals
- 12 bolt rear end.
- Question for Steve Oldani
- understanding the fundamentals of a Lenco
- Thanks GM Jim!
- Transmission Strength
- What posi unit and gears should I use?
- Aluminum flywheel question
- Best way to getr treanny lines nice and tight to the tranny.
- Reading Gear Patterns
- what year 12 bolt
- question - gearsets for GM 8.875" 12 bolt rear
- 700r4 late 2-3 shift
- Ford 9" Rear?
- 68 clutch peddle vs 69 clutch peddle
- 68 camaro transmission
- I committed to a 700R-4 today
- My Moser 12 bolt install so far
- Chevelle 12 bolt rear worth getting?
- lockup conveter
- 350 lockup trans
- Bowtie overdrive going bad already?
- Posi type? Please help !
- m20/m21
- Transmission/Clutch squeal
- driveshaft dilema
- Gear Vendor
- Drive line/rear-end shop in Miami?
- Converting Column Shift to Floor Shift
- Converter bolts won't loosen
- auto to 4 speed floor pan hole?
- Z bar set up 67 to 69
- Tremec 5 Or 6 Speed
- 12 Bolt rear Question
- Quadzilla 4L80E
- Did I burn it up?
- How many RPMs can a TH350 take
- Strange rear vibration
- hurst shifter
- Leaky 12-bolt - need ideas!!!
- 700r4 First Gear Squak
- Picking up my 700R tonight
- Th400 , Info
- 69 Rear End No Luck On A Decode
- Zz4 Flywheels ?
- worst broke trans i ever seen
- Who's got a 4L80E in there 1st gen?
- Need a drive shaft measurment for a '67 with a M-21 4 speed
- Gearing Question...
- looking in socal for help on weldin spring peaches
- Crossmember Installation Help
- Trans vacuum line question
- Yoke stuck in transmission?
- Wrong torque converter
- Speedo will not go past 50MPH?
- 12 bolt help
- Driving with a 12 bolt posi????
- Tranny to Bellhousing Bolt size.
- 1968 Big Block Camaro Driveshaft - HELP!
- Convertor slip
- 400 sb clutch pivot ball stud hole drilling tips pls
- What do you guys think of this 9" ?
- Anyone heard of "Sach's" clutch?
- T56 bolt up?
- torque convertor with BBC question
- TKO600 or TKO600RR?
- Another 9" Question.
- Question about an 85 z28
- AHHHHHHHHHHH rear end is going out
- clutch issues...help needed.
- 327 to 454 clutch fit issue.....
- How much gear oil?
- Large ring vs. small ring posi???
- 12 Bolt ?
- Cleaning rear end
- Best way to prep/paint rear end??
- powertrax unit differences
- 8.2 need help
- Hurst Shifter Linkage Clips
- 12 bolt tube leakage
- hurst shifter handle removal ?
- Transbrake questions.
- questions on detroit tru trac differential
- Checking Mcleod bellhousing runout w or w/o register ring
- bad pinion bearing
- Converter question
- Best 12 bolt?
- !2-bolt repair Dallas Recommendation
- AOD: Do I drive in "D" or "[D]"
- failure analysis?
- Installing a hydraulic throw out bearing in a 69 with a ROD 6 spd
- TKO-600 Electric Speedo hook-up
- pg to t350 swap what is the detent control valve
- th 350 rebuild problem/what is this?
- speedo needle oscillates, why?
- Transcooler pics needed
- Muncie trans decode help needed
- Hi Guys...New to 1st Gen...Need Help on Diff Width
- Difference between 8.2 and 8.5 differential
- Slow pick up out of 1st gear.
- Pinion Nut Torque
- 10 bolt to 12 bolt swap
- Reproduction 621 Bellhousing
- Help Converting to HorseShoe Shifter...Pics?
- hard shifting t/a 400
- Super T-10 gasket replacement difficulty
- Richmond Super T-10 4-speed GM
- 2004-R TV Install Problem
- second gear start
- vacuum modulator
- T-5 clutch fork return spring
- Clutch & brake pedels
- vibration while going slow
- need quick answer?
- Clutch recommendation
- pics of my new rear end (big sorry)
- 3000 Rpm @65mph
- McCleod bell housing
- 10.5 Clutch Kit 4 TKO????
- Is it the clutch?
- 69 Leaf Spring Mounting Bracket
- How to adjust the clutch fork pivot ball?
- transmission advice
- 74' Z28 Production Numbers
- Driveshaft length 8.2 vs 8.5
- cross member and drive shaft?
- Sub Frames
- Leaking Trans Fluid
- 700r4 Id
- Please Verify 2004R TV Cable Setup
- Need Reccomendations For New Rear End!!!!!
- Doug Nash 5 speed
- M22 69 with no vin, but has a P code
- Rear end clean up
- Axles and 8.5 Nova Rear
- Clutch won't disengage fully
- Please help m-22 serial# and side tag #
- Please help m-22 serial# and side tag #
- Rear Question!
- 8.5 Rear Question..Perches/Shock Plates.
- Nova 8.5 and J.C. Whitney Leafs?
- Needing help from the Ford 9" experts
- More bent/ broken parts?? PICS.
- Setting th350 shift points
- TKO 500 vs 600
- What is this rear?
- Setting Autometer Electric Speedo
- tko 600 pilot bearing ID
- 400 THD need cooling lines?
- 69 Z/28 Lockout Lingage
- Need Transmission Mechanic in Dallas
- decode this turbo 400
- Axel bearing B, M, O, P?
- fairbanks shift kits
- 4 Speed Shifter Hole
- 67 Rear end
- Camaro 5 speed vs horse power
- Need shifter/linkage recommendations for Super T-10 in '67 w/console
- Turbo 350 tail shaft housing gasket?
- About to install my TKO-600... any tips?
- turbo350
- M21 input shaft wiggles
- trans cooler help
- clutch engagement sucks! help me out
- TH350 - Second Gear Slips after 2200rpms??
- Summit Diff Gears.
- Clutch Question
- hypothetical question...
- TKO-600 grinds going into Reverse
- converted from manual to tb 350 won't down shift
- Fine spline vs coarse spline clutch disc???
- Removing tranny to fix sticky clutch
- 4.11 Gears
- Moser c clip brearings very tight
- Auto or stick
- 4 Speed cable adapter question
- ST-10 question
- Valuable old parts?
- t56 tranny problem.
- speedo cable
- finally! my new rear and slide a links installed
- Clutch linkage questions
- 88 Iroc, need new axle info, compatible?
- Multi leaf in mono leaf perches
- Drive shaft loop with Tremec
- GM 10 ten bolts
- Super T-10
- Clutch pedal stop?
- Spider gears, pin won't line up - Help!
- Trans Filter?
- Rear end ratio changes?
- Whats the difference in th400 & th700
- Clutch pedal rubber stop 69
- Determining Posi or not
- Borgwarner in a 69 camaro
- Is this rear worth putting money into it?
- TKO Installed!
- Drive gear for T350
- Moser 12 bolt axle vent
- Modulator Part Number
- manual or automatic
- Draining the tranny
- Gear Swap Question
- Another What Stall speed Question
- Need Posi/Gear Swapout Advise
- 8.2 rearend gear swap 4.10 to ??
- Shifter pops out of gear
- Could I use this
- tranny cooler line fittings
- Turbo 350 behind a BB
- Speedo cable hook up. Help!
- Muncie tail housing
- console powerglide shift lever????
- Inch Pin
- Non Camaro Auto Trans problem question
- Where to Buy a Shaft Bolt????
- Speedo Cable
- auto to 4/5 speed
- Transmission Lines?
- 9" housing end question-
- TH-400 1st gear
- need part number for manual trans bushing
- help me out
- Converter suggestions please!
- BB with 4 speed and best gear ratio ?
- Cable Clutch?
- Aluminum Cover Worth It???
- need help to id trans
- drive shaft
- locker and limited slip
- Amount of oil to fill a Muncie
- M20, M21 and M22, ST-10
- (pics) converter ?
- need help id a Muncie 4speed trans
- 67 Chevell 12 Bolt Rear End Fit ?
- Shifter detent plate NEUTRAL SUCKS*^#~