- Differences between car and truck 12 bolt
- bolt torque
- Switch from Hearst to Muncie shifter?
- How does the 5325 handle come apart??
- Having a 200r4 built. What questions to ask?
- clutch replacement
- Has anyone tried the Powertrax lock right???
- 5 speed
- 68 Powerglide floor shift help
- trany.
- do I really need bb shifter rods?
- bb reverse lock-out rod..69
- Can I switch the Guts??????
- 700r4 flairs from2-3
- 8.5" 10 bolt on mono leaf?
- 3138 shifter rebuild kit
- 12 Bolt Positraction Rearend
- three bolt transmission mount
- tranny cooler
- center section/carrier......GM 12 bolt posi car vs truck.....are they the same?????
- rearend decode
- early 69 rear in 68
- speedometer cable....muncie 4 speed
- M20 shift trouble
- 12 bolt cover?
- Eaton or Auburn???
- Holding pinion yoke, final tightening of the nut?
- Engine and Transmission Too Far Forward
- looking for help with a transmission swap
- Help! Cannot install TKO-600 driveshaft
- axle tube ,fix or replace in Pa.
- how much hp have you guys put to an 8.2?
- TKO-600 clutch adjustment - help needed
- 12 bolt purchasing
- Good place to pick up a replacement rear end
- 3:42 gears ?
- 2004R Converter Lockup Question
- Which 12 bolt Limited Slip?
- hurst shifter identification
- torque converter question
- how to tell a 8.2 10 bolt from a 8.5?
- Will a 68 chevy Impala rear fit?
- 8.5" assembly tips?
- converter locking and unlocking
- Muncie rebuild question
- Torque Converter
- got my hurst back up switch mounted and working
- ever herd of summer brothers axles?
- increasing direct clutc
- Clutch return spring
- Alignment in Dallas/FtWorth Area?
- pressure plate help needed
- 1968 muncie shifter
- '70 Nova 10 Bolt in '68 Camaro
- Rear end compatible? (12 bolt from Impala)
- Identifying Hurst shifter linkage rods ?
- When to change Shell rotella oil after break in??
- Rearend ratio advice
- TCI 700R4, yes,no?
- STRANGE rear end....anyone
- Shifter won't go in to Park???
- Speedometer gear
- Need speedometer help?
- Does anyone remember seeing a complete bolt in 12 bolt rear for about 1,200?
- Powerglide to TH350 swap
- do I need a new converter
- What would your put in? Poll...
- Tire revolution gear calculation??
- clutch type
- clutch type
- saginaw 4 speed
- Bad Tremec Shifts
- TCI Streetfighter th350
- Does anyone have some pictures of installed clutch linkage?
- Swapping to a 4 speed
- 700r4 to 68 327 flywheel ?
- 9" Limited slip diff question
- Spool/C-clip
- turbo 350 help please
- Driveshaft length
- 4L60E problems
- flywheel/clutch options
- Rear End - WTH?
- rpm rasing!!!!
- rpm rasing!!!!
- Driveshaft slip yoke slack?
- leaky pump seal?
- 700 crossmember ?
- 12 Bolt Rear Shims
- Excellent Article--History of Tubro-Hyrdomatic Transmission.
- constant or variable ratio
- Art Carr website 700R4 vs 2004R
- What else does it fit?
- 8.5" Axle Tube Bent
- posi teardown
- Torqing ring gear, question?
- Love that T56 6 Speed
- speedo gear selection
- M21 w/ over drive 4th gear (0.87)
- 406 SB with rebalanced 302 flywheel?
- single axle length?
- Traction Lock for v6 Camaro?
- External Transmission Coolers
- TKO Sticky????
- 700r install lines?
- 8.5 posi unit
- M20 leaking?
- u-joints and things?
- TH350 - short or long shaft?
- 12 bolt Pro gears on street
- 67 12 bolt?
- Anyone have a pic of a moser 12 bolt on the pallet?
- 1350 Universal joint, Overkill?
- Help! Turbo 400 or Muncie 4-Speed???
- 12 bolt rear
- Muncie or Saginaw 4 sp
- M20 or M21?
- 12 Bolt?
- Another 67 12-bolt question
- original shifter dismantle
- Another Muncie ID
- Muncie or Tremec 5 speed
- 700R4 shifter question?
- wrong gear position in Muncie
- Transmission Seal Leak
- Firebird Trans. Crossmember Work In Bb Camaro?
- Basic Muncie Questions
- Help for newbie
- Reasonable Cost for an M-22?
- Picked-up my Moser 12 bolt last night
- Converting a 12 Bolt to Posi
- posi identification
- What transmission?
- 4- speed swap
- Question: Is it true that manual transmissions save gas better than automatics?
- 96 camaro differential
- Differnt driveshaft lenghts?
- Super t-10 id? (no grooves?)
- 12 bolt ID help needed
- I just pulled this rear end out
- Adapting Transmission hard line to AN
- Another Flywheel Question...
- Help Please!!!
- any drag racers using a th350?
- TH400 Forward Clutch too tight????
- What not to find in a T-350 pan
- 1967 4 speed transmission removal
- Question for people who have a DNE or Richmond 5 speed
- 3 speed 6cyl to 4 speed v8 ?
- Clutch Spline ??????????
- Transmission acts funny
- Converting from 3 on the tree to manual ?
- Help with correct Speedo Gear
- 700 won't shift into OD at 3/4 throttle
- What size convertor?
- Reverse light Switch
- Reverse light Switch
- 12 Bolt Reinstallation problems
- Powder Coating driveline?
- 1350 yoke. Fitting problem? Question.
- strength challenge.....M-20 vs M-21
- speedo gear
- Pinion preload, loose - tight?
- Driveshaft Length difference.
- That doesn't look like a TH350
- 12 bolt rebuild kit
- Braided trans lines?
- TCI Pans
- Gear pattern pictures, comments please?
- 67 Tubular Crossmember?
- new tire size
- Help identifying rearend
- looking for TH400 detent solenoid
- exploded view of original hurst shifter
- vent for Moser 12 bolt
- Could it be even more Rear-end IDing???
- Trans swap, which one and how
- ClassicChevy5Speed.com
- TKO-600 shift quality poor
- Monster Transmissions??
- Part number for 69 Z flywheel
- Hurst shifter handle #6900 what does it fit???
- 10 bolt vs the world
- Preparing the 8.5 for gear shop and got a ?
- Speedo Drive Gear
- Torque Convertor..
- Powerglide Capacity
- 12 Bolt Pinion Seal Leak
- fire and gears
- auto to 4sp
- TH350 Leaking Fluid At Filler Tube
- Powerglide removal from engine
- Building up my 12 bolt for a 67
- torque converters?
- Transmission issue?
- Chevy Punch
- Speedometer Cable Insert?
- tranny line fittings TH400
- THM 400 , give me tips to beef it up ---
- Please help setup in switching from open to posi but using same gears.
- ring and pinion change
- TH2004R into stock '67, ...couple questions.
- A thanks to Big Gear Head
- am i missing somethin'??
- Need General info on a '69 rear end.
- Problem with Hurst Shifter
- Scattershield install
- Keisler 11" Bellhousing
- Rear end frankenstein
- detent cable
- who here runs a built (aftermarket) 4L80
- Big Block Crossmember
- 67 camaro floor
- Need 12 bolt rear end help
- rearend decodeing problem
- 12 BOLT DECODE ....Please
- Rearend Centering
- Axle bearings bad?
- My Tranny Tip Of The Day
- 67 rubber shifter boot?
- Wheel studs into axle flange, torque to...?
- Rear pinion seal
- M21 or Clutch Problem?
- rear end (spool vs posi traction)
- 79 camaro tranny swap
- Muncie M21
- Autogear Super Muncie
- He shoots...He scores...
- Bent axle tube opinions please
- 3:42 or 3:73 behind BBC and Turbo400???
- Rear ends
- 3:73carrier vs 3:08 carrier
- Will this work? th-350
- gear oil????? switching from open carrier to posi
- 4l60e for free?
- flywheel cover
- Gears
- Rear end gear advice
- Need advise 427 bb and st10 bad combo?
- Switching Saginaw out for Muncie
- auburn posi worn out?
- What size pinion yoke
- Muncie vin stamp
- Throwout Bearing Position on Fork
- It's been too long but I'm getting ready to install my TKO... Linkage/pedal question
- throttle valve question
- Optional rearend for 68 camaro
- Rear end gears
- Clutch Break in
- Kickdown linkage on TH350