- tranny fit question
- chevy 833 4 speed
- 12 bolt rear info
- Ever heard of a Hurst "Bastard" Shifter?
- Clutch fork/TO bearing alignment issue
- 67 camaro rear
- Muncie to bellhousing torque?
- converter lockout question
- TKO mounting bolt problem
- 12 bolt center housing
- I am looking for a rear end, what are my options?
- Driveshaft fit
- tractor hyd oil
- 1967 Muncie conversion
- coil over front shocks
- 4 spd Sag with 68 shifter in 69.....?
- M20 Repairs - Books?
- 700R4 Torque Converter Suggestions and Brand Experiences
- Tremec question
- Original 3.31 or upgrade to posi 3.73?
- L89`s" in Camaros?
- Chevelle 12-bolt
- TKO 600 Third Gear Blues
- NEW Tremec T-56 MAGNUM Specs and Availability
- Shifter Linkage Removal
- clutch linkage installation
- shift linkage
- Hurst shifter/stick alignment issues
- '67 12 bolt
- Incorect TH400 shift pattern
- Positraction Differential lubricants
- Truck bellhousing
- Is it OK to resurface a pressure plate?
- transmission drain plug
- 12 Bolt posi - thrust washers
- Saginaw 4 speed length?
- Trans Am & camaro rear ends
- where do I find muncie 4 speed parts
- have you seen this before
- Polished alum. 700r4 dust/inspect. cover
- Borg Warner Super T-10 in a 69 Camaro
- flywheel 153 or 168 teeth
- Speedo gear question
- speedometer cable length
- Been a while....
- best way to access speedometer gear
- 75 Nova rearend???
- 2000 camaro tranny
- clutch z-bar mount
- 9" gear setup $$$
- trans brake
- Deep pan-stock crossmember
- gear oil
- gear shifter installation
- Replacing my Muncie
- Clutch Pedal Bellcrank Bracket Question...
- Axle Fabrication In South Carolina
- Wilwood brake kit for 12 bolt, 3.15" bearing, staggered shocks?
- Clutch recommendation
- TH350 problems-need advise
- M22 decode
- Tranny Experts: TH400 Identification
- Turning higher RPM's with TKO 600....
- 1969 camaro, turbo 350 or 700r4?
- options for getting rid of the column shift linkage
- What to look for when buying a used transmission
- TCI or B&M Auto Trans to hold 500 ft lbs??
- LT1:auto to manual tranny=> Chip programming
- Stock 200R4 HP?
- 700R4 HP & Torque Rating?
- What Auto Transmission?
- 700r4 vs 200r4
- 69 coupe correct way to adjust front bearings with drum brakes
- Changing gears
- Question for Keisler Guys
- Reinstalling Original Muncie Shifter
- 67 auto shifter location
- drive shaft
- Will a 3.08 gear with a turbo 350 be doggy?
- Cooling line install question th350
- which cars
- rebuild a 200r4 or buy built?
- 700r4 without lock up
- Lakewood, tremec 5 speed info
- Stinky Clutch-Is it toast?
- TKO 500 or 600?
- Installing pinion angle shims
- One for the Ladies
- 200 4R Conversion
- Clutch/throw out bearing issue?
- Throw Out Bearing Alignment
- 1969 Conversion
- Has anyone done a bellhousing alignment before!
- 94 Z28 Auto to 6SPD Swap Speedo Problem
- rear wheel wobble
- Torque Converter Brand
- Torque Converter Stall Speed?
- Torque Converter Diameter?
- TH400 Leaking
- Modulator pipe hose
- Crossmember
- Driveline Vibration
- '69 Camaro 307 Power Glide Transmission question
- Changing from Auto to std tranny?????
- Is a locker dangerous? More dangerous with a stick?
- tubs
- 69 rear end width
- Trans cross member- only one bolt on right side
- Shift kits?
- 91 z28 transmission swap
- stainless tranny lines?
- What torque converter do I have?
- Thinking 200r4
- m20 gets stuck in 3rd and 2nd
- Torque Recommendation?
- What Clutch is best?
- Started 4-speed conversion today...
- Torque Converter Advice Needed
- Muncie Transmissions
- 3.23 & tko 600 rr
- 1969 clutch return
- which Muncie for '70 Z28?
- 200-4r governor
- Detroit True Track
- Trans suggestions...
- trans swap
- Will a 460486 bellhousing work!
- Camaro/Firebird Crossmember - Dont interchange?
- New muncie transmissions
- tranmission / speedometer gearing / correct speed
- M 21 Geting Noisey
- 700R scatter shield?
- Classic Industries 621 bellhousing
- 12 Bolt Cross Shaft Pin Diameter
- Muncie Date Code
- Flywheel questions '69 10.5 clutch
- How to remove pinion yoke?
- trans
- speedo main gear replace,how much work?
- Trans to BH bolts- what size are they?
- 1969 rear end swap
- Speedometer gear formula?
- clutch pedal help
- M-20 tailshaft bushing replacement
- Zoom HP Circle Track Clutch Kit - right one?
- tko 600 part needed
- 28 or 30 spline?
- Moser 12 Bolt/3.15 bearing - Inner housing seal install
- Flywheel Cover Help
- help getting transmission out!!!we cant get it out,please help!
- Hydraulic Throwout Bearing Problems w/ M20
- 4 speed crossmember
- !2 Bolt 4.11 Posi to 3.55 Posi
- Setting pinion angle
- Best place to buy th350/400
- Orange bellhousings?
- Will this 10 bolt fit my 67 ?
- Help selecting gears - identifing 4 speed
- Axle/Differential Help
- TKO 600 question
- ZZ4 install - which flywheel and how to remove fork?
- Wrong linkage on '69 with Hurst and M20?
- automatic transmssion slips at high rpms?
- Gear Lube
- Transmission alternatives
- Hurst shifter won't go into reverse!
- Will 700r4 non lockup still have .70 4th gear
- Decoding Transsmisions?
- Axle seal instruction
- Hurst installation sheet needed
- Tremec T-56 Magnum update
- Shifter ?
- Rear end setup
- Confused by diff setup (9 bolt)
- quick leaf spring question
- replace both axles or one
- LONG Mfg shifter.
- New 12 Bolt Moser (still out/dry) clicking noise - Normal?
- Has anyone used a Long shifter in a 67'??...
- Rearend making noise need help identifying what it could be?
- Clutch going out, Which clutch should I install?
- camaro axle
- Factory traction bar
- Rear end ?, strange clunking
- Transmission help????
- Leaf spring question
- Kickdown Cable Removal.
- 6 speed tranny
- Muncie Shifter? what car?
- Kickdown bracket
- machined axles
- 79 camaro rear for 67
- fuid change
- Pinion Angle Shims
- WOW! What a difference!
- Speedometer not working
- Any Good Books for Rebuilding a 12 Bolt Rear End
- Moser axle bearing???
- Auto to manual, flywheel question
- Th400
- Hate to ask but....
- TH400 42 teeth driven gear in wrong sleeve
- 12 bolt rear
- pilot bushing -How deep?
- Question for Big Gear Head
- Tremec Issues/Concerns
- Auburn vs Eaton, US gear/strange vs richmond
- clutch and pressure plate question?
- Bellhousing question
- 5 leaf spring install question
- Muncie doesn't shift into first
- Some Moser-Wilwood prettiness
- Does driveshaft change going 12bolt to 9inch?
- Auto To 4Spd
- TV made easy settings.
- tko600 clutch question
- New Shifter...
- a manual automatic
- How can I make a 700r4 shift sooner?
- TKO 600 3rd gear problem
- T-400 lines
- Trans oil cooling lines
- 68 rearend
- 68 Rear end swap
- 2004r Transmission Advise
- Muncie Transmission
- '68 10 bolt upgrade
- Anyone know 4L60E tranny cooling line fitting sizes?
- Who has pic's?
- differential question
- 4L80E diesel to gas conversion???
- Gm 12345349 vs gm 1052931
- power steering pump 67 camaro
- Valve body differences.Casting number. Please help!!!
- rear end help!!
- Richmond Super Street 5speed
- Cost to Swap Muncie M20 for Automatic - ADVISE PLEASE!
- 12 bolt advice please
- any good books on rebuiling a rearend...?
- Disc brake swap
- fluid leaking from kickdown cable
- GM Crate motor and old SB flywheel
- 700r4 tranny mount
- pilot bushing help
- Break-in of rear...
- TH350 late shifting, need advise
- Clutch help
- 68 Camaro Shift Tube
- New T-56 Magnums on the way
- 73 Z28 Differential Question