These pictures turned out kind of fuzzy, but I'm hoping to get some help on what they are. They are from a '68 RS vert total basket case. I thought I knew a good bit about these cars, but after sorting through the boxes, I actually had to label a box, "stuff I don't know what it is!!!". I can probably take more photos, and even some of individual stuff if that helps. Thanks in advance for any help. Brian
http://i28.photobucket.com/albums/c237/68Vert/DSC09626.jpg
http://i28.photobucket.com/albums/c237/68Vert/DSC09625.jpg
http://i28.photobucket.com/albums/c237/68Vert/DSC09624.jpg
http://i28.photobucket.com/albums/c237/68Vert/DSC09623.jpg
http://i28.photobucket.com/albums/c237/68Vert/DSC09622.jpg

Boy, these photos are worse than I thought after I previewed them. I'll go ahead and post and see if I can get some answers on some of the parts. Then, the ones that are left, I'll get better photos of them. Thanks again, Brian

I see a rear middle bumper brkt (top pic bottom brkt).The bottom pic are rs bellcrank support brkts. Dewayne

Middle picture, right hand switch is the reverse back-up switch for manual transmission.

The item to its left is an aftermarket under-the-dash bracket for most any stereo item bought in the 70's & 80's, before DIN was standardized as it is today.

The rest, your at the mercy of the fellowship here, may the force be with you.

in the first pic on the right is a fuel tube cover for a 67-68 camaro. In the third pic the right top bracket it I believe is a e brake clip and under it it a back up switch

the very bottom are rs brackets

Fourth picture down, two slotted brackets in lower right-hand corner are outside mirror door base brackets.

Bolt this base onto door, attach mirror to center hole. These are aftermarket, not OE.

fourth pic down on the bottom left is also a rs part

Okay, thanks for the help so far!!! Someone said the thing on the right side in the first pic is a fuel tube cover. Where would that mount?

Weird I have a reverse light switch for a manual. As far as I can tell, the car has been a PG all it's life. But, a lot can happen in 40 years I guess. The only parts I was pretty sure I knew what they were are the two brackets in the last picture. Saw a pic of them in a supplier catalog and pretty much figured that one out.

The ones that are really confusing me are the large bracket on the left in the first pic and both brackets on top in the second pic. I think I'll try to get you guys some better pics of them. Thanks again, you guys are great!! Brian

The fuel cover slips into two slots in the trunk floor about the filler tube and gets attached by a screw at the top of the trunk latch structure.