silverbbbb
Oct 26th, 02, 02:41 PM
Hello, I am putting a big block in my 67. I am using an Edelbrock performer manifold with a Holley DP carburetor; will the stock flat hood fit? I am using frame mounts from Ricks. Thanks for any advise.
|
View Full Version : Will a stock flat hood fit with a BB?? silverbbbb Oct 26th, 02, 02:41 PM Hello, I am putting a big block in my 67. I am using an Edelbrock performer manifold with a Holley DP carburetor; will the stock flat hood fit? I am using frame mounts from Ricks. Thanks for any advise. Rsmith1969 Oct 27th, 02, 03:22 AM Depending on what intake manifold you use i dont see why not, The Performer Intake is a stock height intake but if you use the Performer RPM or Airgap then you are using a Highrise and may have clearance Problems. [This message has been edited by Rsmith1969 (edited 10-27-2002).] [This message has been edited by Rsmith1969 (edited 10-27-2002).] RamJam Oct 29th, 02, 05:05 PM It should, 67 & 68 were very simular and some 68's came with the 396 bb motor. |