Anyone have their dual exhaust exit on same side, probably passenger, in front of the real wheels ala NASCAR ??? Prefferably a first gen.

Don't think I've ever seen one???

pdq67

Well I'm looking at using some Dr Gas boom tube tips. They have them for single and dual inlets. I was just kicking around the idea of running both pipes out the passenger side of the car in one boom tube like the cup guys do. I also can get single inlet tubes to exit each side of the car.

Check your state laws first - it's illegal in some states to have the exhaust pipes exit forward of the rear wheels unless it came that way from the factory (midyear Corvette sidepipes, '92-'95 and '03-'08 Viper, etc.). :thumbsup:

340 T/A 6-Pack Challengers too!

pdq67

Good point. But there are a lot of cars here in my area that are like that. But I'll double check anyway.

Do you have room?
No way I could do it... Just ain't that much air between the subframe connectors and the world.
Not sure how good they'd look exiting forward of the front spring eye, either, that's almost at the door.

I back halfed my car and run coil overs in th rear. My rear frame is maybe 1/2" below the stock floor braces since it's tied in with the stock front sub frame. Looks like i should have plenty of room. Especially using oval pipes.