Here's another question for you 1/4 panel replacement experts. My new quarters don't have the pins for the rear window moulding clips.

What's the best fix for this? Cut out the old ones and weld them on?

------------------
1967 Camaro coupe since 12/24/66, '98 WS6 Conv, Y2K Corvette Conv

You can buy the screw in type at a good auto body supply house, or resto house for 10-15 cents each.

You could also install the studs with a "uni-spotter" or "stud gun". If you don't have access to one a good body shop could install them for you.
Austin

Thanks for the reply. I had no idea these things were available as screw on parts.

I guess that shows you what a novice I am.

HOT GLUE

------------------
http://www.67rs.com/macphreak4evr/chrissig.gif
Chris's 67 RS 327, Comp280,Flowmasters,shoddy interior, pepboys carpet and rusty floors and trunk can be seen at http://www.67rs.com
JOIN THE CAMARO NET WEBRING!
http://nav.webring.yahoo.com/hub?ring=camaronet&list

hot glue????? Ah...no

heheheh, I actually have the same issue, but I didnt find out untill workin around the rear window one day, I was planning on using the screw ins, but i will have to remove the rear window to get them in place...

[This message has been edited by Chris Edwards (edited 08-09-2001).]