Hi everyone. Has anyone used any of the repro '69 front inner fenderwells with any luck? I need to replace the pass. side as it was damaged in a past crash. I have been looking for some good stock ones but with no luck. Figure I'll have to use repro's but am leary about the fit. Any ones better then others or all they all crap? Thanks. graemlins/beers.gif

I bought a set from D&R at Super Chevy a few years back. I was pleased that they fit as well as they did. I did have to drill a hole for one wheel well bolt, it was off by about a 1/4 inch. For the most part, they worked fine.

I installed one. It fit fine but one hole was not punched. It was the one that attaches to the radiator support down low. You probably can drill one there yourself. I would not hesitate to buy another repro one if I needed it.

-Mark.

I bought them from Rick's. The fit was good, slightly less weight but a good product. I too had to drill the hole by the radiator support.

What about fiberglass inner fender wells? Less expensive and can save some weight, if your into that kinda of thing

www.up22.com (http://www.up22.com)

Thanks guys. Glad to hear they are not total crap. graemlins/thumbsup.gif