My doors dont have the holes to mount the bracket that the cup pull screws in to.
id like to see a pic with the bracket installed if someone has one handy.

Thanks Joe

You're one day late. I just finished putting my trim panels back on. However, I will most likely have to take it off again since the new inside door handle mechanism didn't have the screw hole and I didn't realize it until I went to put the inside handle on. I'll most likely be taking it off again. I can take a picture then, if you still need it.

You're one day late. I just finished putting my trim panels back on. However, I will most likely have to take it off again since the new inside door handle mechanism didn't have the screw hole and I didn't realize it until I went to put the inside handle on. I'll most likely be taking it off again. I can take a picture then, if you still need it.

thanks ,when you get a chance that would be great, I put my panel back on with out the bracket till i figure out exactly where its gotta go.
Thanks Joe

when I get home in about 3 - 4 hours from now (depending on Bay Area traffic) I will snap a pic and post it for you...