What are some good hearders to put on a built 350. I got a 67 ss. My friend had a set of 350 headers but seem they would be only inches off the ground when installed.

I have hooker super comps on mine and really like them. Ive heard some folks say they hang a bit too low but i have never had a problem.

What are some good hearders to put on a built 350. I got a 67 ss. My friend had a set of 350 headers but seem they would be only inches off the ground when installed.

The only engine you should need headers on is a built engine, the unbuilt ones don't run....

I went with the doug thorleys. I heard that the hookers (driver side) hangs lower than the passenger side. That was a concern for me since I will be lowering my car with the Hotchkis TVS kit.

What kind of power increase did you notice with Doug Thorley's?

What kind of power increase did you notice with Doug Thorley's?

Wish I could tell ya..my car is still a work in progress..thorleys still in the box sitting next to my crate motor...unfortunately..still in the crate! :o

I have Summit ceramic coated ($178!!) headers on my 68 Camaro. They seem to hang evenly, but, the pass. side sits about 3 inches further to the back, and I also had to slightly bend one tube in about a 1/4" to clear the steering box. They do look good! Your 67' should be the same as my 68 under the hood. Good Luck!!

I was just gona say that guys have said that the cheap Summit Dynomax headers are supposed to fit pretty good for cheaper jobbers!

pdq67