ok i need to know how to remove my axle, what i figure is drop the driveshaft remove the third member cover and a c-clip? or does the axle just slide out im doing this in a few hours and i need to get it done quick because i work, ha ha ha nothing like brining it right down to the line lol

Go to the search and put in axle removal...there is a ton of stuff there,should be able to find any type rearend you might have and removal of axles

If all you need to do is pull an axle, you don't need to touch the driveshaft.
Pull the cover, rotate the diff until you can get the lock bolt out, slide the pinion shaft out a lil, then rotate the diff until the window is facing you and there is romm to pull the shaft farther out. Pull the shaft out untill it just clears the axles and c-clips. Then push the axles in, the c-clips will often fall out or can be easily pulled with your fingers.

Your Drive shaft can stay in unless you are changing the pinion seal/or gear.

Remove the rear cover and drain the gear oil.
Remove the cross shaft retaining bolt and the cross shaft.
Push in on the appropriate side axle from the wheel.
Remove the "C" clip and the pull the axle out.

Installation is just the opposite.

If you have to pull the axles you might want to look into doing a c-clip elimitaion. A little extra safety for the $$. Just a thought.