I just received some rivnuts for my new floor. They are for the console mounts. After measuring and searching, I contacted Debbie at Liberty Engineering. That company has the correct rivnuts for our cars. Debbie was so kind to send me a couple in the mail at no cost. The part number is S31-125 and they are 5/16-18 thread. If you want to contact Debbie at Liberty Engineering, the phone number is 1-800-257-4838. They are in Chatsworth, California. Please make sure you tell her that Scot Long, referred you. These rivnuts are what we all have been looking for.

Scot

Excellent infomation Scot!

Now, the best way to install them without a rivnut tool?

Joe, check out this link, it has been on here before I think.

Homemade rivnut tool (http://www.fjr1300.info/howto/rivnut-tool.html)

Someone can probably improve this method. But it still works.

Scot

Works for me!
I must have missed that.
Thanks Scot.
:cool:

See my post in this thread for an even simpler installation method and tool, and a source for aluminum riv-nuts (much easier to work with than the steel ones):

http://www.camaros.net/cgi-bin/forum/ultimatebb.cgi?ubb=get_topic;f=3;t=005585

graemlins/beers.gif