I am interested in hearing some opinions on a gas cap that I am going to look into having made. I plan having a couple made out of an ABS plastic by a rapid prototyping company and then I will have them chromed. The reason I want to have the rapid prototyping place make them, is because I can have sharp corners (or very small corners) and have the lettering be raised more than what a mill could handle with a small dia end mill. I have 2 design ideas and was wondering what the thoughts are.... Also, there is a minimum charge of $250 for the order, so I could have 2 made for $165.00 each (not including the plating) if anyone would be interested. It wouldn't have to be the same design either, if anyone would like a cap to say something else it could be done. The backs of the cap would have stand-offs on them, so all you would have to do is drill out the stock locking mechanism and screw it to the stand-offs.

I like your idea, I have an LS motor in my 67 but.... I prefer the orginal SS cap that came stock.

Maybe I would change my mind if I see the final product.
Post up some pics when you get it finished.

Rich

good idea but i'd rather have the billet shaved one.

I'd be more proud that you have a first gen Camaro then that is has an LS1 in it. If it were me, I'd stay away from the LS1 on the gas cap - just my opinion though. I think the cap borders on looking "cheesy" and would look a lot better with just SS or also consider the other ones that have been posted in similar threads that I think are respectable looking mods. Of course it's all about what you want but that's my .02.