hi i have replaced complet front end cant put grill in its to tite the old one came out in pieces in old front end why are these so tite and i have to drill holes in new trunk lid for spoiler are thair ruber bushings that go in the holes. is thair a spoiler instal kit thanks

Rubber bushings do not go in the holes,although there are some guys on Ebay who sell a nice set of rubber washers to seal things up. The factory called for some sealant around the holes.

As for the trunk lid, most guys makes their own template. Here is a pic of the basic measurements. NOTE: This is only a GUIDE...whatever you do, do not drill any holes until you verify things are going to align by making your own cardboard template.

As for the grille,loosen the header panel,as well as the header panel support bracket. You may need to remove the bracket. Once you do, install the grille, then re-install the header and the bracket. If it fits too tightly, use some shims under the bracket so that the grille is not crushed.

http://i22.photobucket.com/albums/b339/belairbobs/spoilertemplate2.jpg

nice template bob. :thumbsup: i wont say nothing on where you got that lol.:D