Hey Guys, I bought one of those rear disc brake set ups from the Right Stuff company. Everything bolted up fine, except the only thing I cant figure out is on the brake pad and ciliper, the set up came with the small metal brake pad retention spring. For the life of me, I cant figure out how these get attatched. If anybody has some input, it would REALLY be appreciated.
thanks in advance

If the calipers are the seville type cast # 020,021 then the spring clip should fit into the groove near the outside edge of the piston and there should be a couple of bends in the clip that push against the back of the pad slightly to keep the pad from rattling when the brakes are disengaged.