Anybody used the 1 inch front sway bar from them and had problems with the end links? The bar is at about a 45 degree down to the end links and they seem way smaller then the originals. Should I just look at replacing these with a better end links kit and if so who makes a good kit? Thanks for the help.

I have to say that my original ADDCO 1" front s/b end links w/ the aluminum tube spacers, worked for a while but were really CHEAP!

I ended up buying a set of aftermarket poly end links and rethreading and cutting them so they fit properly as well as brench grinder ground-pointed the poly bushings so that they would center in the holes!

Worked great!!

And you have to have your car down on the ground w/ the weight on it to adjust it so that it is level as best you can get it w/ the bottom A-arm.

It's a real pain, but you will need to fit it and then cut the steel tube spacers and the rethreaded bolts until you get it right!

Been there, had to do it and it works fine..

pdq67

would a new set of original rubber end links work?

I would stay with the poly ones. Like Paul said, you need to get the car at full wieght and ride ht, then check, measure, and cut if you need to. You can get another kit with onger sleeves if you need longer. Try to get the bar as close to horizontal as you can, but the sleeves need to be at least a 1/2" long or it may bind up.