I am planning on putting RS Rocker molding on my 67 convertible but I am not sure how. There are brackets that need to be drilled (ouch!) and screwed onto the bottom of the fender, doors and the quarter panel. The doors are easy cause I can get to the back of the door to put the screws on. How do I get the screws on the quarters and fenders if the car is already put together? Do I use the screws or another method of fasteners?

On my '67 SS/RS, the front fender and rear quarter moldings screwed right into the sheet metal, as per factory.

The door part was the only section that used those pesky clips and speed nuts inside the door panel.

So, make sure you're all lined up and drill a hole SMALLER than the provided sheet metal screws and have fun ...

David