What do I use to coat a aluimiun intake with that has been bead blasted to keep it looking new? Thanks

------------------
johnny

[This message has been edited by johnnyr (edited 12-31-2000).]

Eastwood has a hi-temp satin finish clear that should work OK - good to 500 degrees.

------------------
JohnZ
'69 Z28 Fathom Green

You might consider a clear powder coating.

Clear powdercoating will turn yellow in a relatively short period of time. Also, most clear paints will do the same.

How long the paint lasts depends on your carb. I have not owned a Holley that has not leaked. Once you get gas on the finish, it will turn yellow.