How did you get the car high enough to put on the rack? I have an engine hoist, I just thought I might weld some eyelets on the mounts I build and lift one side at a time. I though i would find out how you guys did it.

Any ideas?

Shannon

http://www.1969supersport.com/lift.html

This is a chevelle, but might give you an idea.

Rob

I had the same autotwirler. Use ad 4x4 and jack up the front from the middle of the car. The body didn't need to go that much higher to get the front body mount set nor the leaf spring mounts in the back. You sure your twirler is down as far as it goes?

Pictures are good thanks.

I haven't even tried it yet. Still quite a bit of disassembly needed, just trying to figure "things" out. If a 4x4 and a jack will do it, I'll do that since it seems easier.

S