The rockers on my conv are toast. I rodered the inner reinforcement plates ( backorderd by both Rick's and Classic ). I may go with square tubing instead. It should be strong enough along with my welded SFCs. Anyone done this?

Also, I'm surprised ( and dismayed ) that the inners aren't made. These are the ones the floor pans weld to. AM I wrong here? It would seem to me that they would be easier to develop than the full outes and inner reinforcements now available. If they have to be fabbed, they will but I'd rather not.

Any pointers are appreciated as always.

------------------
Rick Dorion
69 RS Conv,355,M20,4.10's and I don't worry about stone chips ( yet ).

TAKE A 2 INCH SECTION OF GOOD INNER ROCKER TO ANY METAL SHOP AND HAVE THEM BENT UP . I DID THIS AND ORDER THEM FROM RICK'S WELL THE ONES I HAD MADE WERE 10 TIMES BETTER AND HALF THE PRICE OF RICK'S