I'd like to see if anyone can take a closeup picture of the rear RS wheel (quarter) molding installed, where it ends at the front and back of the wheelwell.

The part numbers that I assume to be correct would be 7795063 (Right Rear) and 7705064 (Left Rear). In test fitting mine to drill the holes, I don't know how far forward and back to position the molding.

Many thanks

-Kevin

Kevin, here's the passengers side front (drivers side is the same). Is this what you're looking for?

Ed

http://i61.photobucket.com/albums/h52/bertfam/molding.jpg

And here's the passengers side rear (again, the drivers side is the same).

And yes, that's bondo you see! The car needs new quarters...

Ed

http://i61.photobucket.com/albums/h52/bertfam/molding-2.jpg

Yes, thank you; that was what I was looking for. I wanted to do a test fit and drill the holes before going to final paint. I tried to take some pictures but my camera does not like the flash reflection off of the fuel tank or something, so below is the best that I could make of my situation.

I have new Goodmark quarters, and there is a 'notch' on the lower back of the quarter and it causes the molding to fit strangely. My '69 quarter panel has that similar feature, but its a non-RS car. The lower rear screw hole either has to not be used or all or placed at the extreme lower portion of the quarter panel lip. What I did not know was where the front of the molding started and your picture helps a lot. I now know that I have to probably mount my RS molding first or at the same time as my trim to make sure it all fits.

Thanks again; I think these pictures will help others who need to know how they fit.