We can get USA made sheetmetal in limited quantities while supplies last. Post up what you are interested in. Be aware that USA made metal will cost 25%-35% more than imported metal. Example: 70-72 Chevelle full quarters stamped on GM tooling. As close to NOS as you can get. Price for these is $575 each where others are $460 each Goodmark price for imported metal. About 10-15 sets available right now. If you are interested in other USA metal for Camaro, Chevelle, Nova, etc., let me know. Mostly what is available right now is floor and trunk panels, upper dash, inner and outer wheel houses, and convertible quarters.

Mike,Not to go off post but any insite on the header bolts? When you do here somehting I want the gaskets with them.

I am waiting on Percy's to call me this week. They said they were enroute and shouls have them any day. I can get black oxide now if you don;t want to wait on the stainless to show.

Mike

Mike no rush dont mean to bother,just thought I'd drop a line instead of bothering you on the phone.When you here something just let me know.Thanks again......Dave

I need the drivers side under seat rear pan and pass side rear floor board. For a 67 camaro. Any Idea of cost? I can wait on floor board, but the under seat pan is holding me up.

Scott