Does any one know the dimensions of the six conv floor brace bolts and head markings? Also, the same for the four bolts that secure the trans cross member to the sub-frame?

Thanks

Bob

Bob, you mean the bolts that hold the X brace across the middle that strengthens the bottom and protects (blocks) the drive shaft and exhaust?

Mine looks pretty original, maybe I can get under there in the next day or so and check mine for you.

Of course, someone here probably already knows this by heart and can beat me to it.

-shoe

I think mine may be original so I went out and removed one. It has what looks like a capital E in the center and three dashes one on the top, one on each side. Nothing on the bottom of the E. It has a loose washer about 7/8 of an inch. The length looks to be 1 1/2 inches with 1/4 inch being the tip that comes to a point. The head is 1/2 inch and has a small lip around it.

Firstrs/Shoe

Thanks to both of you for your reply. I was hoping to match the originals with something I may have.

Where else could you such an obscure question, and get an answer!!!!

Thanks Again

Bob