I did a search (really!) and the question was asked but I couldnt find the answer.

I am about to install the rocker molding on my 69. Does the "flat" edge face up or does the "rounded" edge face up?

Also, I have the assembly manual for dimensions for the SS fender emblems, but I am not sure where the starting point is to measure from. Any suggestions?

Thanks, as always

joe

------------------
69 396 w/SS Trim
Badboatdude@CS.com
69 Pics http://albums.photopoint.com/j/AlbumIndex?u=1506559&a=11674961

[This message has been edited by Joe G (edited 06-13-2001).]

This doesn't necessarily mean that its right, but on my 69, the flat edge is up. The guy who put my car together has had 69 Camaros since the early 70's so he should know.

Thanks. I think it looks right that way, but only want to install it once!

joe

------------------
69 396 w/SS Trim
Badboatdude@CS.com
69 Pics http://albums.photopoint.com/j/AlbumIndex?u=1506559&a=11674961

Well, I guess I'll have to wait a bit for the rocker trim. UPS "lost" it. Got the rest of the stuff, though, so I'll be trying to install the quarter louver trim and fender emblems today. Between the templates and the Assembly Manual I should be OK for the holes placement. (I hope http://www.camaros.net/forum/biggrin.gif)

Thanks
joe

------------------
69 396 w/SS Trim
Badboatdude@CS.com
69 Pics http://albums.photopoint.com/j/AlbumIndex?u=1506559&a=11674961