I purchased a project and the former owner had removed everything so I didn't see how things came a part. Does any one have pictures as to how the brakelines from the front of the master cylinder to the rear end were ran. I would sure appreciate it. Mine has 2 lines.
Thanks
Charlie

Charlie - Get an Assembly Instruction Manual (AIM). You will find it in Section 5 B1 and B2. The AIM can be purchased from most of the parts dealers.

Charlie - Get an Assembly Instruction Manual (AIM). You will find it in Section 5 B1 and B2. The AIM can be purchased from most of the parts dealers.

I have the 67 Assembly manual and it doesn't show except for the Master Cylinder hookup. I need to know where it goes down the frame rails. I bought 2 piece line and it is prebent and I can't figure out how it runs.
Thanks
Charlie

im in the same position as 68camtruck, any help would be appreciated!!!

http://www.camaros.net/forums/showthread.php?t=120085&highlight=brake+lines

This might help..the two piece line is for the heavy (air cond cars) that used a valve (metering/proportioning?) under the drivers seat at frame. Mine was one piece.
Anyway look for the original clips under the body. There is a threaded hole for a clip wrapped around the line that attaches to the frame just under drivers foot on outboard side. Holes for valve location there as well if used as I recall. From there the line goes up (from memory) inside of the frame to master cyl. I had to remove steering box to get it in that area, Dont see any pics in my files.