I'm in Houston this weekend doing my 700r4 conversion at a buddy's shop. Does anyone know where I can get a driveshaft cut locally in the Houston area?

Thanks, Joe

Yellow pages . Lots of drive line places there, truck shops.

Yellow pages . Lots of drive line places there, truck shops.



Thanks, I did find a couple. I was just looking for a recomendation from previous experience. I don't think they can screw it up too bad... :confused:

Worst case, I'll have to buy a new one from Denny's.

Thanks, Joe

If they can't cut and balance, I would move on.

Randys Driveshaft in Houston. 713-672-6344

They are off I-10 and McCarty.. 8025 Market ST.

They do all my driveshafts. You had better call them, I dont know if they are open saturday.

Thanks Mike,

That's who I called, they are not open tomorrow so I will have to wait till next week.

Thanks again guys, Joe