I am going to be replacing a fair amount of sheet metal on my 69 camaro in the months come. I was hoping that there were a few write ups on the following items. I have searched, but can only find small amounts of information here and there.

I am looking at replacing the tailpan, top dash, and wheel lip and rear 1/4.

Thank you

do a search....there are several posts with pictures.....look at cheby2's post as there is great pictures in there. I have several disassembly pictures, but no reassembly ones yet in my post.

Chris (Arai) is right -- check out cheby2's thread as there are many detailed photos of his work -- I have a few in the link on my sig for reference but cheby2 has some very good ones

Cheby2's post is awsome, my stuff on floor pans is kind of a hodge podge, to many screws to be practical, but I'm retired and thats all I have to do.

Anyway, on my floor pan installation it shows the size and drill bit that will pull the pans down tight to the supports, then you can see some of the tools that you could use, anyway, for what its worth.

Its on my web site, it might give you a few ideas.

Rob

I can help a little in your area of need ;););)

www.howardsbackyardautobody.com :beers:

Vol 2 :thumbsup::thumbsup::thumbsup: