Guys
I have been installing inner and outer fender wells on my pace car.I was wandering what hole at the front and back of the outter wheel well purpose is??
Thanks,David

Those are the alignment holes for the factory. One half of the wheelhousing was placed on 3 dowel pins and the opposite half was then placed over the pins and welded together. Made for a faster and more acurate alignment of the two halves. Be sure that when you install the two halves together you align those holes.

That makes sense. I always wondered why they put the holes up an inch or so off the bottom. I thought they were for drainage and the location was an engineering screwup. I also like how water drains out of the back window area. graemlins/angry.gif

Hey Jonesy
Those are the two holes I am talking about. What is their purpose? Also, how does the water drain from the rear window.I am going to put in a new rain gutter and have been scratching my head on how it drains.
Thanks,David

The water drains into the channel that the glass sits into and slowly rusts it out. :D
Sorry the devil made me do it. I just refinished that whole rear window area due to rust there. Keep an eye on it, there are no drains designed into that area.
graemlins/clonk.gif

Oh, sorry..I misread thew topic redface.gif I think those holes are so they can apply undercaoting to those areas after assembly