Sorry guys, it's a little off the Camaro subject.

I've seen the dent pulling system where a pin is spot-welded to a steel panel and a slide hammer attached. Is there a similar system available for an aluminum panel?

------------------
The Red Beast http://www.geocities.com/casanoc

Carl,
Not to my knowledge but that doesn't mean they don't exist.
Check with your local body shop supply house or even a Mercedes and other European body shops. They might have an answer for you.

Carl, We use a piece of alum welding rod.Depending on the type of alum sheet metal you have use same type of welding rod.you can cut to various lenghts,works well.Same slide hammer as with steel.

Brian Weil.