What is the size difference between the two if you were measuring for a new driveshaft?

I have a 1310 now and a 1350 ready to go in, problem is I would rather not have to put the 1350 in just for measurements, then take it back out and put the 1310 in again so I can drive the car while waiting the 3 weeks for the driveshaft to be ready.

I have heard it's ~1/2" difference?

I did the same thing last year.The drive shaft lenght did not change only the size of the u joint did.Because of the larger size of the 1330 yoke.

I did the same thing last year.The drive shaft lenght did not change only the size of the u joint did.Because of the larger size of the 1330 yoke.

Thanks Fred but I'm talking about a 1350 which is definatly longer, and you are correct the 1330 and 1310 are the same length.

3 weeks for a driveshaft? You must not have someone in your area that does this type of work. In the Sacramento area I can get same day service on custom built driveshafts.

Hmmm....

3 weeks for a driveshaft? You must not have someone in your area that does this type of work. In the Sacramento area I can get same day service on custom built driveshafts.

Hmmm....

Denny's driveshaft is who I'll be going with, they are quite busy this time of year.

Two days to build mine from Inland Empire. Quality stuff. Are you enjoying waiting?

Oh don't worry I'm driving the car, in fact we just got back from a 700 mile round trip family and all. When I do put the order in I'll still be driving while waiting. It would probably be 2 weeks to get it from IED to Canada.

Why Denny's you ask? Well they are 20 mins from me so I'll pick it up, and they offer lifetime warranty and free labour for rework such as shortening/new ujoints etc...

I just noticed all the Fred's in this thread! Hey that rhymes