Does anyone know if I can use the original style alternator brackets for small block V8 avail from Rick's? I have headers and a Weiand intake right now, and I am trying to restore the A/C as I go. I am not sure if the OE bracket will attach to my intake since there is no thread on the front of the intake. Maybe I should use the Z28 brackets? Any suggestions?

I have P/S too and have not seen many pictures of the original configuration. I'm pretty sure the alternator and P/S pump will be on the driver's side together (which is not how it was configured when I got it). I'm also not sure if there is a P/S adjustment bracket that does not attach to the exhaust manifold.

http://www.rickscamaros.com/product.asp?pf_id=ALT-26&dept_id=3213

You can use Rick's bracket using only the water pump bolt. Or, get a '66 and older upper bracket and use it as it used the water pump bolt.

Power steering does not attach to the exhaust manifold. A plate bolts under the engine mount on the block and a cradle bolts to the front two bolt bosses on the engine block front.

RE: Alternator. Thanks. I think I will try the original bracket.

RE: P/S. Do you mean this bracket?
http://chq.temphost.net/cgi-bin/chq/W-095.html

Do you happen to know of any pics of this setup? I have not found many good pics of an original engine compartment for a 67 with A/C and P/S.

Thanks again,
Derek

Your suggestion would work. I'll look for the bracket(s) I am talking about.
I can't take pictures of mine as I'm in Lima, Peru until the end of the month.

This is almost like the one I have, this bracket uses the the two front engine mount bolts as mine fits between the mount and the block and has the slot in the same location.
http://www.parts123.com/parts123/yb.dll?parta~dyndetail~Z5Z5Z50000136c~Z5Z5Z5AAQSL~ P29.95~~~~S2EZ0MS4KR19081625114a~Z5Z5Z5~Z5Z5Z50000 136c

In this setup can the alternator lower pivot mount to the head or do I need this thing?

http://www.rickscamaros.com/product.asp?pf%5Fid=C%2D9008&dept%5Fid=3141
http://www.rickscamaros.com/product.asp?pf%5Fid=C%2D9254&dept%5Fid=3141

Right now I have something that looks like this:
http://chq.temphost.net/cgi-bin/chq/W-747.html

The OE lower mount is simuliar to the F-bracket and it bolted to the exhaust manifold.
The combo you shown is for a exhaust header set-up.

The bottom item is the spacer between the alt and pass head on a 69 & up set-up with a long water pump.