Hello All,

Need to know two things:

1) which of the three holes below is correct for "sticking" the throttle linkage through?

2) is the bolt/tab correct for the kick-down linkage on a TH350? Is it in the correct location?

Thanks

http://www.members.cox.net/flowjoe/images/P1020927.JPG

Not sure about the kickdown, but a road test should tell you which hole that one goes in...

On the throttle, I checked some photos I have of other cars, and most seem to have the throttle in the bottom hole in the upper part of the linkage. You should be able to figure this one out too once it's back on the car.

Hold it to wide open, and see which hold works with your pedal. Good luck... Brian

Not sure about the kickdown, but a road test should tell you which hole that one goes in...

On the throttle, I checked some photos I have of other cars, and most seem to have the throttle in the bottom hole in the upper part of the linkage. You should be able to figure this one out too once it's back on the car.

Hold it to wide open, and see which hold works with your pedal. Good luck... Brian

Thanks for the reply. The throttle linkage will adjust to reach any of the three holes so I really need to know which one is correct both appearance and for proper leverage. Unfortunately I can't discern from the AIM which is correct:mad:...guess I'll have to look more closely.