Here are the specs:

406 small block
Iron Turbo jet angle plug heads(fully ported)2.08,1.66 stainless valves
Comp 298 solid cam(.548 lift) crane 1.7 rockers
1 3/4 headers(try it with 1 5/8's if possible)
10.5 to 1 CR with flat top forged pistons, shot peened rods, victor jr intake manifold, 800 cfm holley double pumper, double roller timing chain.

If anyone has that online quarter mile deal thing where it tells what you'll run...
It also has a:
TH350
full manual valve body, 3200 flash stall convertor, 3.73 posi rear-end

Thanks a million,
Donnie

ttt, come on somebody...?

I would do it for you, but I have no idea what these heads are that you mentioned you have. I need the flow numbers for these heads to give you "accurate" HP and torque numbers....

Also, is the lift for the intake and exhaust the same for this cam?

Is the victor Jr. considered a single plane manifold?

Get me this info and I'll fix you up with some numbers...

[This message has been edited by lakemg (edited 11-30-2002).]

I have no clue what the flow numbers are one the heads so just try it with some good, average and poor flowing heads if possible. Yes, the victor jr. is a single plane and yeah the cam is single pattern.
Thanks alot bro,
Donnie

<BLOCKQUOTE>quote:</font><HR>Originally posted by 1968camaro123:
Here are the specs:

406 small block
Iron Turbo jet angle plug heads(fully ported)2.08,1.66 stainless valves
Comp 298 solid cam(.548 lift) crane 1.7 rockers
1 3/4 headers(try it with 1 5/8's if possible)
10.5 to 1 CR with flat top forged pistons, shot peened rods, victor jr intake manifold, 800 cfm holley double pumper, double roller timing chain.

If anyone has that online quarter mile deal thing where it tells what you'll run...
It also has a:
TH350
full manual valve body, 3200 flash stall convertor, 3.73 posi rear-end

Thanks a million,
Donnie<HR></BLOCKQUOTE>

Ok, looks like I need a bit of help with the cam. I could not find a Comp Cam 298 on comp cams' website. I found a 294 but it has a .525 lift, so if you could give me more information about your cam, that would be great or if you could send me the link to your cam that would be just as good. I'm looking for Lobe Center Angle, Intake Center Line, Intake Duration, and Exhaust Duration.

Thanks,

Marty

1968camaro123,

I've emailed you an early Christmas present so check your email. Let me know if you have any questions.