I am rebuilding an original points distributor.
Should use a special lubricant on the main shaft when assembling ?

Thanks

Dielectric grease. It is pretty much available at any autoparts store. And don't forget the plastic seal that goes over the well (which should be filled with dielectric grease).

I think the figure for endplay is .012-.020" Shims are available from Summit to adjust that if you are out of spec.

Also, check out this thread:

http://www.camaros.net/forums/showthread.php?t=131187

alan

DO NOT reem or hone the sintered bushes...uwill kill their lubricating properties and cause fast and exessive shaft wear.
and a special tool is used to put theses in...they are pre machined to size.

These bushes should be soaked in oil BEFORE fitting

I would really like to get my hands on rebuild information. GM data etc....
Eager to learn more and do this rebuild correctly.
Thanks
Ray