Ok I installed my MPI and went with the Holley 700R4 hookup and there is no way in hell it will work, I contacted Holley and they said it will work but the cable loops upward and than has to be pulled down to straighten out. Has anyone hooked this setup before and how did they make it work? I went with the MPI over the stealth ram so I could hook everything up easier and hook up the cowl hood setup.
Thanks,
Mike

I have never seen anything from Holley, do you have a picture or a link to it?

I had to be very creative!

Here is a picture of how I did it with the chevelle and my wifes camaro:

http://www.1970chevelle.net/tvsetup.jpg

http://www.1970chevelle.net/camlink.jpg

Good luck,

Lee

I used the same bracket, Holley #20-95. Won't help without a cable throttle though.

Jody

Hey thanks guys, I just tossed my stock throttle asssembly for the Lokar unit for 67-69 Camaros, and it uses a cable. So I need Holley #20-95?
Thanks again!
Mike

I've used that Holley #20-95 on several cars with t.v. cables. It has a tab that locks it from turning which your throttle body may or may not have. I milled a slot in my first one and built a brace on the others. Still the easiest way I know of to hook it up.

Here's a pic of one of mine to give you an idea.
http://www.camcojb.com/zl1index/zl1motor.jpg

Jody