HEY,Im looking to find a ignition cylinder blank,that a locksmith can cut to fit my key

..

Locksmith should have blanks, GM ignition key design been around a long time.
But any key shop should have it, unless its a VATS key, then any GM dealership with ownership papers, i.e., registration to you.

if your looking for the "old style" GM blanks there are a couple of places on ebay that had them for @ $2 each 2 yrs ago.

I bought a bunch of those GM keys off of ebay. Finally was ready to key them. All the locksmiths in my area have converted to "mobile" locksmiths :( Went to Home Depot and had a young man key them (4 keys). Brought my door and trunk locks in to make sure they fit before leaving the store. He did a fine job, the GM blanks were a little different from the generic keys I had, but he adjusted them fine. Went to pay and he said since I brought my own blanks in he cannot charge me :D Seems HD charges by the key blank, not the cutting. Dont buy a blank, no charge! :hurray:

I got extra keys cut at the dealer about 4 years ago.
I now have an NOS ignition tumbler (with red notch) and 2 pristine original door locks. There was a guy on ebay last year who was going to fit the two door locks to the ignition key. I don't know if he's still around, but his email was 1greatdeal@comcast.net.

A tought on keys
My door and ignition are the same...the rrunk different but goes in the ign fine not work

I have a spare ign key hidden in the trunk
I have a spare trunk key in the center consol

The car was stolen a while back..they couldnt fire her..(an old post)
They found the trunk key, fitted in the ign, and they broke it off...which is fine by me cause trans and steering are still locked.

A 1st gen I can get into in 20 secs...thu the alarm makes one hell of a racket lol