Can I get someone to run this combo please!

383
9.8 cr
6.0 rods
AFR 195 eliminator 75cc
Comp XR276HR
http://www.compcams.com/Cam_Specs/CamDetails.aspx?csid=159&sb=2
1.52 comp magnum roller rockers
KB Forged flat top (4.9cc)
Edelbrock air gap intake
Holley street avenger 670
1 3/4 SS full length headers, 3" exhaust
Head gasket bore is 4.130 with .038 compressed thickness.
Block has been zero decked.

Thanks

For a 383 I would up that 670 cfm carb. to a 770. :)

Have you got an air flow chart for those heads? Valve sizes? Nevermind, I found the specs.

423 HP @ 6,000 RPM and 440 TQ @ 4,500

Nice power curves, you're above 400 TQ from 3,000 to 5,500 RPM.

I have a very similar 383 with home ported TFS 215R heads
Comp 224/224 hyd. roller, 10.8:1comp. rpm intake and 750HP,
and 1 3/4" dyno headers it made 490hp @ 5900 and 495tq @ 4500.
I would think with more comp. and a better carb you should make about the
same power.

thanks guys.
I will udgrade the carb soon as soon as I have the funds.

Any suggestions on a bigger/better carb.
BTW: The car is a 4 speed (m20), 12 bolt posi 3.73.

What's the redline gonna be? Unless you are gonna crank it to insane RPM, your current carb should be ok for now.