Can anyone tell me what's the height of a Moroso stamped steel tall valve cover for small block Chevy . I've got of set of Edelbrock Elite Tall that seem really tall (4 1/2"). I'm going to use a stud girdle with the heads but I like the Moroso look better. Any help ?

Rich,

Here you go. Measured from the compressed gasket surface to the inside near the radius = 3 1/2". From the gasket compressed surface to the slightly raised center area inside the cover (where the Moroso logo is stamped = 3 5/8". However if you run their baffle kit it is only 3" from the compressed gasket surface to the botom of the baffle.

Dave

Thanks Dave, I thought those Edelbrock's looked a little too tall. Thanks Again !