So here is my dilema.:confused: I just about have the complete replacement trunk floor welded in my 67 vert and I am looking forward to the next step. I have been told that I should install the rear valance and then the tail panel next? I plan to mock up the inner/outter wheel houses and the fit the complete quarters that I am using. I was going to use sheet metal screws to mock the parts in place. My question is though if I get everything aligned satisfactory do I weld the inner/outter wheelhouses together outside of the car? or are they installed inner, then outter and then weld together? Also at what point should I be putting the rear seat divider in the fit? Do I install that after the wheel houses are welded in since it just basically gets sandwhiched between inner wheel houses? There is probably more than one approach to this but could really use someone with experience opinion/advice. Thanks in advance. Jeff