|
: 383 Kit 1NAST69 Jul 17th, 00, 10:47 AM Can anyone tell me who has a good quality balanced 383 kit available? Price is definately a concern, but I want as much quality as I can get for a reasonable price. I will need Crank, Rods, and Pistons. Thanks for the help. DOUG G Jul 17th, 00, 10:58 AM A lot of companies make the 383 kits,lunati,american speed,and the list is long...goes on and on.check these people www.strokermotor.com (http://www.strokermotor.com) ------------------ My68Camaro (http://hometown.aol.com/dougs68camaro/index.html)This CamaroNet - the Webring for the 1st Generation Chevrolet Camaro site . Doug G. 68 Camaro 406 ci. bruce69camaro Jul 18th, 00, 06:03 AM check with northern auto parts. i bought several engine kits off of them and they nice stuff. prices are good too. bruce rlrr Jul 18th, 00, 08:00 AM I just installed my 383...about 200 miles so far. I used Powerhouse. They were fantastic!They were extremely helpful and made sure my combination was going to do what I wanted (600 hp with Nitrous). They also have a lot of other parts extremely cheap, roller rockers, timing sets, etc. They are in almost every car magazine you pick up. Let me know if you need more info. Mike her69 Jul 19th, 00, 07:55 PM You might also look at SpeedOMotive also. Their kit is great quality and the price is resonable. They have a website it is www.speedomotive.com (http://www.speedomotive.com) hope this helps. CORNHOLIO Jul 20th, 00, 04:02 PM I agree with her69. I have got kits from them in the past. They have alot of options with their kits. 1NAST69 Jul 21st, 00, 01:09 AM Thank you to Doug G, Bruce69Camaro, rlrr, Her69, and CORNHOLIO for your help!!! ------------------ 1969 RS/SS CAMARO 350 / 4 spd. Rallye Green 69-ZMAN Jul 23rd, 00, 03:01 AM I used the Eagle 4340 internally balanced kit... top quality stuff got it for 1850$ ....... has JE pistons, rings, 4340 h beam 6" rods and 4340 crank included, I know 1 person who is using this same setup in a 1000 HP dragster and it's living real well.... I'm very happy with the setup as well ------------------ keepin' it original 69Z Red Rocker Jul 23rd, 00, 01:36 PM You might try PAW. I have over 70,000 mi. on one of their short block kits w/small valve camel hump heads/crane valve train/ performer manif. w/750 vac. Holley on my '70 El Camino. It's very torkey. P.S. Do'nt forget a 400 balancer & flex plate! Bob [This message has been edited by Red Rocker (edited 07-23-2000).] | ||