Can someone help me with the measurement between the rear subframe bolt holes??...center to center

I have 2 subframes here and they are way off...i think one is bent, just want to make sure....

Thanks team Camaro...

thats a 69 Camaro BTW

See post #15 in this thread for diagram with measurements: http://www.camaros.net/forums/showthread.php?t=139129&highlight=alignment

What a great web site! How long did that take? Six minutes. Wow.

I found you can adjust that dimension with the transmission cross member.

Roger

I just removed and measured my sub frame (69) for square, and all numbers were within 1/8 inch except the back of the subframe your asking about. My car is a no hit body but even with that going for me it was off by 1/2 inch. Everything lines up great however so dont be too worried about a small discrepancy.