Guy's newbie here with a door question,the doors on my 69 have a couple of rust spot's on the very bottom,probably about the size of a dime,one spot on driver door and two on the passenger,do they make a patch panel for this,i hate to throw these away because they are super straight on the outside,btw great forum guy's.THANKS!

If they're small, just cut out the bad and replace it, you don't need a whole patch panel.

There's really no patch panels that I know of for the doors. Could be wrong.
Like Mike said, cut out the bad stuff, which will no doubt end up being a lot bigger than a dime, and weld in new metal.
If you have any old panels\doors\etc. laying around, use them to make your patches.

Classic Industries has patch panels for the lower part of the doors. I'm sure other vendors would carry them also.