Does anyone on here know where I could pick up a Nutsert installation tool?

http://www.imperialinc.com/items.asp?item=0068850

Harbor Freight Tools has them as does Menard's. I know there are no Menard's in Texas but perhaps Lowes.

Jeff

I picked up one from Homepro Fasteners on Ebay. It's around 100 bucks as a kit but worth it. I've actually used the tool more than I thought I would.


http://cgi.ebay.com/ebaymotors/RIVNUT-RIVET-NUTSERT-TOOL-COMPLETE-KIT-w-NUTSERTS_W0QQcmdZViewItemQQcategoryZ107060QQihZ022 QQitemZ350182788906QQrdZ1QQsspagenameZWDVW

I bought mine at Menards, use it a lot.

I bought mine at Menards, use it a lot.
And for a lot less than a hunert bucks I'll bet.

Jeff

There's actually a tool for that?!?! Damn it, and here I've been using an Allen wrench, bolt, couple of nuts and lock washers.

And for a lot less than a hunert bucks I'll bet.

Jeff

I bought the menard's tool before the homepro kit. I wasn't impressed with it so I took it back. It all depends on if you want a tool to get the job done or one that works good. You get what you pay for.

do a google search for the hand operated tool that MARSON mfg...........

I already had their pop rivet tol and am converting it over to the rivet nut tool............

I then bought 100 1/4x20 riv nuts on line from HANSEN rivet company in Calif for $18.00+ plus FedEx Freight.....

I'm going to be installing rivnuts into certain walls on my P.U. truck bed to fasten aluminum tie down track for securing loads with...........

do a google search for the hand operated tool that MARSON mfg...........

I already had their pop rivet tol and am converting it over to the rivet nut tool............

I then bought 100 1/4x20 riv nuts on line from HANSEN rivet company in Calif for $18.00+ plus FedEx Freight.....

I'm going to be installing rivnuts into certain walls on my P.U. truck bed to fasten aluminum tie down track for securing loads with...........


I hope your loads arent very heavy. I would not trust a nutsert for very much pressure load. They will probably just pull out.