I did a search on where the wiring on the front parking lights goes into the engine compartment on a '67 RS convertible and came up empty(looking for photo). After searching the AIM with not much help, I am looking for a photo of where both grommets go into the inner fender both left and right.... trying to get this stock location. The inner fenders are GM but there is no hole for the grommet to go into???? I may be missing something here.

Does anyone have a RS '67 and have some photos of where the front parking light wires attach?

I am guessing that sine there are no holes I will have to drill a good size hole to get the grommet to go in....

thanks
brandan-

Below is a picture of the left side of the core support. Hope you can see the hole just to the left of the center of the picture in the inner fender. The hole is at the end of the blue & purple wire which is the parking light wire. The right side hole is in the same location.

Roger
http://i193.photobucket.com/albums/z177/roger62305/VRHR.jpg

This is another picture from the front. The hole is just to the right of the core support in the inner fender.

Roger
http://i193.photobucket.com/albums/z177/roger62305/ParkingLiteHole-1.jpg

thanks Roger, that is what I was looking for. I will have to check when I get home to see if that hole is there....

brandan-

Since this is for a convertible, I guess there should be room for the front cocktail shaker. I just put the front shakers on this weekend.....

My car is a coupe so your on your own as far as the shakers. The parking light wire isn't very long so the hole must be close to that location. There should be a much smaller hole just to the side of the grommet hole for the ground screw.

Roger

I will check it this weekend, still on the road. For some reason I don't think that the holes are there but not 100% sure. Thanks, find out more saturday.

Brandan-