I have a 1997 camaro with a 5 speed manual transmission. I am only missing one step to having the transmission pulled out. I don't want to pull the clutch out so i'm trying to disconnect the clutch fluid hydrolic line and i'm not sure what this is but a manual says it's a clutch pedal to master cylinder pushrod which is what i need help with. I'm so close to having this finished but i've hit a wall. please help!

I would think you could just unbolt the slave cylinder from the bell housing, or split the line at the bellhousing/transmission.
It should be the only fluid line going to the front driver side of the transmission area...

I guess I am not really sure what you are asking.

ok so here is the deal now. i got my fluid line disconnected and got every bolt pulled off of that transmission and clutch but now the sob won't slide back. it's like it's still caught on something even though every visible bolt is pulled out. any input anyone?

you need too pull the slave cylinder off and pull on the fork to disconnect it from the bearing. than it should slide right back. since it is a 97 it should be a 6 speed tranny.

Did you get the bolts on the top of the bell housing?

well since mine is a 1997 v6 model it only has a 5-speed. I know the transmission is a T-5 transmission. I've taken the bolts of the top corners of the bellhousing, which were a pain in the *** to get too, but i pulled off every other bolt unless there is one that you can't get to that i'm not seeing

ok, never mind everybody. i figured it all out and swapped out my old transmission with a new one