I am bolting together a 69 camaro front valance and the lower fender extenstions. I have a drawing of measurments of the two holes in the lower center bottom of the valance and the lower holes in the fender extensions where the braces go. Can someone measure thier car for me and see if these measurments are correct. I really would appreciate it. Thanks

http://img.photobucket.com/albums/v70/ardad/69spoiler.jpg

Braces? For the spoiler?
I can measure mine, but what dimensions are you specifically looking for? Hole diameter, or where they are on the valance?

I need to know if the holes on the bottom of the fender extenstions are 53 1/4 inches apart from one side to the other. I want to make sure the pieces I am using are going together correctly. Thanks

No problem....
:)

Look at the header panel good as I had to do some weling and bodywork on it to get it to lign up with the fenders....

I need to know if the holes on the bottom of the fender extensions are 53 1/4 inches apart from one side to the other. I want to make sure the pieces I am using are going together correctly. Thanks Yes it is 53 1/4 inches, just measured mine. From the bottom fender extensions/were the valance brackets bolt up to the spoiler.

Hey thanks that is really going to help.