|
HOTROD69CAMARO Aug 9th, 01, 05:10 AM I have a 330hp crate motor with vortec heads and I've swapped the cam and instsalled a comp xe262h and holley 750cfm vac secondaries. Would any of you guys with the dyno program and tell me if the cam bumped it up according to the computor. Thanks. ------------------ Black 69 camaro [This message has been edited by HOTROD69CAMARO (edited 08-09-2001).] 67RS502 Aug 9th, 01, 06:23 AM Just guessing, but I think it can make 400hp 400+tq with an RPM intake, a 1" spacer and 1 3/4" headers. Just guessing, sorry. ------------------ 67RS STREET CAR, 502 PUMPGAS, HYD. ROLLER, TH350 w/ATI 10" 12-BOLT w/373 - 10.92@125.2 ON MOTOR, ET-STREETs w/MUFFLERS HOTROD69CAMARO Aug 9th, 01, 06:37 AM It has 1 3/4 primary headers and is advertised at 330ft/lbs of torque. I dont have the dyno program and was just looking for anyone that has it to run the numbers. Thanks Mike. ------------------ Black 69 camaro czar Aug 9th, 01, 01:35 PM hey hotrod69, chp says the cam swap put your 350HO in the 390HPish backet w/262xe....and in the 400HPish bracket w/268xe. there are dealers that sell the motors w/xe cams....they'll sell ya the dyno slip that verifies chp's claim....so, hope that answers your post... have fun w/it! [This message has been edited by czar (edited 08-09-2001).] HOTROD69CAMARO Aug 10th, 01, 05:49 AM Thanks guys.I'll have the car to the chassis dyno soon. We'll see what it puts to the ground.60 HP seem awful generous with just a cam swap.The comp cam numbers arent that much different than what it had from GM. But we shall see. ------------------ Black 69 camaro [This message has been edited by HOTROD69CAMARO (edited 08-10-2001).] | ||